Honda Jazz Zündschlüssel

3 Antworten

Hab den selben Honda, im Schlüssel die Knopfzelle eventuell wechseln, vorsichtig arbeiten!

1   by olduser1 on 19 Nov, 2010 14:39

Post actions   Post actions    View the profile of olduser1     Report to moderator  

Try this set of actions from a USA Honda site: Perform each of the following three steps in order, then repeat all three steps two more times, for a total of three times each:

  1. Turn the ignition switch to the ON position, marked II.
  2. Press the LOCK button.
  3. Turn the ignition switch to the Off position, marked I. Do this three times! Next, turn the ignition switch to the ON position (II) for a fourth time. Press the LOCK button again. The door locks should now make a cycling sound, indicating that the system has entered Programming Mode. Press the LOCK button one more time to program this remote.

If you have other remotes to program, press the LOCK button on each one in turn. The door locks should make the cycling sound after you press LOCK on each remote. You may program up to three remotes, and they must all be programmed within ten seconds of each other. Turn the ignition off and remove the key. The are now programmed and may be te

Funktionert einwandfrei bei Honda Jazz ll zum programmieren einer neuen Fernbedienung nach erfolglosen Versuchen vorher :

vielleicht ist nur die Batterie in Schlussel leer, ging mir auch schonmal so

hab ich noch nicht gewechselt, aber wäre unlogisch wenn das gleich bei beiden Schlüsseln der Fall wäre...

0

Was möchtest Du wissen?