Frage von Julius887, 107

S6 edge seitenbildschirm fehler?

Seitdem ich vor ein paar Tagen mir das neue Software Update heruntergeladen habe, gibt es bei meinem S6 edge ständig Fehler mit dem Seitenbildschirm! Wenn ich ihn öffnen will oder teilweise auch zwischendurch geht ein PopUp auf indem steht Seitenbildschirm angehalten. Was kann ich tun und habt ihr auch das Problem?

von R3HAX, 93

Kannst einfach die letzte stabile ROM installieren...

Kommentar von Julius887 ,

dann sag mal wie

Kommentar von R3HAX ,

Hier mein kleiner Guide: 

Flash Samsung Stock ROM (Official/Original Firmware) via Odin

Step 1: Download and install device driver software on your computer.

Visit Samsung official website to find the correspondent driver software.
Google the driver software of your device. Download and then install it on you computer.
Download or update Kies, part of which will install or update drivers.
Once drivers are installed or updated, it is highly recommended that you restart your computer.

Step 2: Download and extract the Stock ROM (Official/Original Firmware).
SamMobile may be the best choice to download stock firmware of Samsung device. Or you can go to Samsung Updates, XDA Forum or Google to find the correspondent firmware of your device. Samung Stock Firmware Download on SamMobile

Click "Firmware" and enter your device model

Select country or type in certain info to filter, eg.Baseband version.

After downloading it (normally a compressed file), you need to extact/unzip it to certain location of your PC. The file types that Odin uses are *.bin,*.tar and *.tar.md5.

Find the file you have downloaded and then unzip it to Desktop.

You will find a *.md5 file after extracting.

Step 3: Download and extract Odin on you PC.
You can download Odin V3.10.7 directly from SamMobile. AndroidMTK is a fine alternative, it also offers a detailed list of Odin versions and download link. Or you can always Google "Odin download".

After downloading it on your PC, extract it to Desktop or another location you'd prefer.Odin v3.10.7 downloaded from SamMobile

After extracting, right-click to "Open as Administrator". It may prevent certain issue from happening.

Run Odin as administartor is recommended.

Step 4: Boot your Samsung device into Download mode.
Follow these steps to enter Download Mode/Odin Mode

Power off your device
Press and hold Volume Down key, Home Key and Power Key
When your device vibrates, release Power key while keep holding the Volume Down key and Home key
Boot into download mode
Warning before entering into download mode

Press Volume Up key to enter Download mode, which has a green robot figure and “Downloading… Do not turn off target!!)
Boot into download mode
Now you are in download mode.

Step 5: Connect your device to PC.
You device should be automatically recognized by Odin. At the lower-left of Odin interface, it should show a message that says "Added!" and in the meantime you should see a light-blue box at the ID:COM section stating "COM:3" (the number depend on which USB port you have plugged the device cable and is irrelevant).

Connect device to Odin

Device is connected to Odin.

Step 6: Click "PDA" or "AP" to add tar.md5 file that you have extracted and then "Start".
Whether it is "PDA" or "AP" depends on the version of Odin that you used. But the md5 file goes to either "PDA" or "AP".

Add *.md5 to Odin.

After adding the file, click "Start" to begin the flashing process.

Click "Start" to flash.


Starting to flash stock rom via Odin

Ongoing flashing process. Do not remove your device.

When the flashing process is done and if everything goes well, you should see a big green box saying "RESET" or "PASSED" (depends on the version of Odin is used). By now, the device should be rebooted and it is safe to remove/unplug your device.

Succeed to flash stock rom via Odin

Do this on your own risk ! I`m nor responsible for bricked devices ! All your Data is now lost! Do a Backup before flashing !

Bitte sehr !

Keine passende Antwort gefunden?

Fragen Sie die Community

Weitere Fragen mit Antworten